This post will go through the fabric requirements for a quilted table runner we’ll make over the course of this week. I’m using the PFAFF Performance 5.2 to make quick work of the piecing. Set aside a little time each day for each step and you’ll soon have your very own festive runner. Enjoy!
With Thanksgiving comes the opportunity for plenty of get togethers involving eating. Whether it’s for a main course or a more casual buffet, this runner can set the tone for friendly holiday feasting. Use a color palette to reflect the bright harvest season colors or one specifically suited to your decor.
Fabrics with small non-directional designs are best for this runner – or you could use only solids or a mix. Large prints will get lost in the small pieces and directional prints may cause you unnecessary grumbling during construction 😉 I’ve kept it simple and bright using only a few colors. You could make it less scrappy in appearance by using the same fabric for each of the small traditional blocks.
½ yd background (gray with flower dots)
fat quarter (18″ x 22″) utensil fabric (black dotted)
one piece 6½” x 20″ platter fabric (white with orange dots)
one piece 5″ x 8″ star fabric (orange daisy)
one piece 5″ x 5″ shoo-fly fabric (green daisy)
one piece 7″ x 9″ knife geese and platter frame fabric (blue lines)
½ yd backing fabric
fat quarter binding fabric
one piece minimum 16″ x 40″ for batting
Cut all of the background fabric
Some of the pieces for the runner are very small, but making the runner throughout the week will go quicker if some of the fabric is precut and ready to sew.
Here’s the breakdown of all the background pieces you’ll need. Cut them in the order listed to make the best use of the fabric:
1 strip – 5″ x 14″
1 strip – 3½” x 14″
2 strips – 3″ x 18″
3 strips – 2½” x 14″
1 strip – 2″ x 18″
2 strips – 1½” x 15½”
3 strips – 1½” x 14″
Subcut one of the 3″ x 14″ strips into 6 – 3″ squares.
Subcut the 2″ x 14″ strip into 6 – 2″ squares.
Cut all of the utensil fabric
We’ll get even farther ahead by cutting out all of the utensil fabric today too. It will be easy to keep these separate from the background fabric because of the contrast between them. Here’s the cutting order for the pieces needed:
1 strip – 3 x 18″
subcut into 5 – 3″ squares and 1 – 2″ square
2 strips – 2 x 18″
subcut into 2″ squares for a total of 17 – 2″ squares
1 strip – 1⅞ x 18″
subcut into 8 – 1 7/8″ squares
5 strips – 1½ x 14″
subcut two of these strips into 22 – 1½” squares
Performance 5.2 ready to straight stitch
I also have the PFAFF Performance 5.2 ready for sewing! You can read my review of this machine here. Needless to say, I’m still impressed with its performance (no apologies for the pun!) For this project, I got the straight stitch needle plate on the machine and changed to a new needle. I’ll be using a neutral white thread for piecing and wound a bobbin with the same color. I also attached the ¼” quilting foot to help me keep my seam allowance accurate and consistent from piece to piece.
With the fabrics picked out and some even precut, the quilted table runner will be a quick project for the PFAFF Performance 5.2. Tomorrow we sew!